clingersz Designer decals for your tub!

clingersz

Designer decals for your bathtub!

A standard bathtub is approximately 60" wide by 20" tall.  Thus, we have designed our decals with that size in mind.  However, we do make a 20" x 20" for the dishwasher and other appliances.  It is not recommended to adhere a cling to the outside of the oven.  The heat may melt the cling and ruin both the cling and the oven surface.

Instructions for STATIC CLING:


Measure the tub to make certain it is at least 59" wide by 20" tall.
If it is smaller in either direction, you will need to trim the cling. We suggest if you need to trim it, do so along the bottom or along the side that is not as likely to show.


Clean the outside of the bathtub area thoroughly.

Tack the cling in place along the top with tape.


Wet the surface of the tub with a squirt bottle or sponge using water and a small amount of dish soap.


Working one section at a time, peel back the paper backing.
Lifting a section at a time, adhering the cling to the outside of the bathtub.
Note: You may want to save the paper so you can save the cling at a later date and reuse it in the future.


Start from the center of the area and work outward.  Using a squeegee, credit card, or other similar item, smooth the cling in place by rubbing along the top surface of the cling forcing out any air bubbles and excess water.  Pat dry.  Enjoy!




Instructions for LOW-TACK ADHESIVE:


Measure the tub to make certain it is at least 59" wide by 20" tall.
If it is smaller in either direction, you will need to trim the cling. We suggest if you need to trim it, do so along the bottom or along the side that is not as likely to show.


Clean the outside of the bathtub area thoroughly.

Tack the cling in place along the top with tape.


Lift a section at a time, adhering the cling to the outside of the bathtub.


Working one section at a time, peel back the paper backing.


Start from the center of the area and work outward.  Using a squeegee, credit card, or other similar item, smooth the cling in place by rubbing along the top surface of the cling forcing out any air bubbles.  Enjoy!

This website uses cookies. By clicking 'Accept' you agree to our use of cookies.

Accept